إنانا
Admin
عدد المساهمات : 3510
تاريخ التسجيل : 03/10/2011
 |  موضوع: كيف تصنعي أصيص معدني أنيق How to Build an Embossed Metal Planter الأحد يونيو 30, 2013 7:49 pm | |
|
Step 1: Clean the metal panel
Brush off loose rust and cracked paint. To protect against toxic lead, which can be released in paint dust, work outdoors and wear a respirator approved by the National Institute of Occupational Safety and Health. Also, pull on a pair of thick gloves so you don’t cut your hands on the sharp metal.
Step 2: Build the box
Fasten together precut 18-by-18-inch panels to form the sides of the plywood planter. I used a pneumatic nailer, but a hammer and 1 ½-inch finish nails will also do the trick.
Step 3: Add bottom panels
Secure the bottom (this is a 16-by-16-inch panel, sliced in two), leaving 2 inches of space in the middle for water to drain through. Then, nail a pair of scrap lumber “feet” perpendicular to the bottom boards. This will help reinforce the box and elevate it off the ground.
Step 4: Wrap the box
Fold the metal sheeting around the sides of the planter, and use a rubber mallet to tap it flush against the wood.
Step 5: Secure the metal
Fasten the metal to the planter box by driving in steel tacks along it’s bottom seam.
Step 6: Cut metal corners
Use snips to cut the corners where the metal overlaps the top of the planter.
Step 7: Cover the edges
Fold the metal over the planter’s top edge, tap flush against the inner walls, and secure with nails. To preserve the patina and prevent more rust, apply an exterior-grade polyurethane sealant such as Rust-Oleum American Accents Clear Top Coat Spray.
Step 8: Drop in the insert
Insert the plastic liner, and fill your new planter with flowers.
| |
|
